Precautions for Upper and Lower Molds in Plastic Process

During the plastic process, the upper and lower molds need to pay attention to the following matters to ensure that there will be no accidents during the plastic process.

1. Check whether the screw hole in front of the upper mold is slipping. There should be 6 sets of coders on the top to prevent the coders from being locked tightly.

2. When the upper and lower molds are hanging, they need to be 20 cm away from the ground. The ring of the placement ring will not touch people or damage the ground; note that when the mold is lifted, people cannot stand under the mold, and pedestrians are prohibited from passing under it.

3. Check the oil pipe and water pipe regularly to prevent aging.

4. When the upper and lower molds are connected to the mold temperature machine, the mold temperature is higher than 70℃, and the mold cannot be connected to the glue pipe to prevent the temperature from being too high and hot water from blowing over people. Use high-pressure oil pipes.

5. When the upper and lower molds are connected to the front and rear mold oil pipes, forcibly remove the ejector pin of the guide column from the bottom of the machine balance column to prevent the oil pipe from being crushed.

6. When the single mold is completed, turn off the heating pipe temperature control box, turn off the power valve of the mold temperature machine, and remove the oil pipe and heating pipe to prevent injury.

Qingdao Xueyu Molding Products Co., Ltd. is mainly engaged in the design and manufacturing of injection molds, injection molding and secondary processing (spraying, pad printing, ultrasonic welding, stamping), etc. For more information about plastic process, please contact us.

Website: www.xyzmould.com

Address: No.18 Henan Head Road, Henan Head Community, Jihongtan Street, Qingdao Industrial Park, Shandong Province, China

Email: wangmiaotian8@163.com